Automatic screw dispenser, automatic screw feeder machine never gets jammed with crews
Introduction:
1 . Can increase productivity significantly
It is unnecessary to target the screw cap, compared to screw plate, each screw can
save 1.4 seconds, productivity increased by 4 times!
2. Statistical function(partial models)
When the settings achieved, the machine will automatic alarm and cycle, it is very
clear to see with digital display panel.
3 . Automatic alarm function
When non--normal condition occurs, the machine can automatic alarm.
4 . The volume is exquisite, does not occupy the space.
Product Detail:
Waterun-900 Automatic Screwdriver Feeder
1. Easy to replace the rail to meet the change of screws;
2. One machine can cope with 8 different sizes of screws just by replacing the rail;
3. The different rails need to be purchased separately
Waterun-900D Automatic Screw Feeding Machine
1. New technology , the machine will never get jammed with screws .
2. Convenient to operate and fix the problem by the operator .
3. With self-detecting system for machine breakdown .
4. Rail adjustment range : M1.0-M5.0
5. Digital display prevents error occurred .
6. Automatic circular counting with fixed quantity .
Technical Details
| Model | Waterun-900 | Waterun-900D |
| DC power supply | AC220V, DC12V 500MA, AC Adapter |
| Applicable screw length(under head) | Up to 20mm |
| Rail adjustment range | M1.0-M5.0 |
| Speed of picking up | 1.5 sec/piece |
| Product size | 180 x 125 x 150mm |
| Weight | About 3kg |
Features:
1 . Adjustable for a wide range.
The track can adjust freely to suit many kinds of types screws, like M1.0--M5.0 O standard screw(1.0 1.2 1.4 1.7 2.0 2.3 2.6 3.0 3.5 4.0 5.0), special screw, 1:1 short screw, filling piece screw and so on.
2.Running smoothly.
The screw s movement and roll down inside the bucket, all the screws will be cleared if
not enter the rail and enter the n ext circle, screws will never be blocked, the check point
will not vibrate.
3.Working speed adjustable
Feeding system and drive system independent control, set the time delay freely to adjust
the feed speed, suits many kinds of works
4 . Simple operation
Even novices can operate freely, whether metric specifications or british specifications,
all easily to understand.
Problems and solutions :
| Malfunction | Reason | Solutions |
| Screw Feeder can't work | 1:Power supply broken,2:Switch is broken | Replace the broken part |
| Power indicator is on,but the machine can't work | 1:Front/back sensor block the signal； 2:The motor power cable is cut | 1:check and adjust 2:Rewelding the wire |
| Screw stuck in rail | Up and down brush . The gap between the rail or the position of high limited plate is wrong . | Making the adjustment after checking |
| Dropping the screw | The up/bottom adjust plate didn't installed very well | Adjust the position of the adjusting plate . |
| Vibrating all the time | 1:The speed of vibration is too big , and the setting delayed time is to long ； 2:Front/ back sensor was in the wrong place | Making the adjustment. |
| It is too slow to give out the screws . | 1:The screw feeder was put on the unflat place； 2:The speed of vibration is too small ； | 1:Re-adjust the angle of the rail ; 2:Adjust the speed of giving the screws .； 3:Lengthern the time of delivering and giving the screws . |
Product Tags:
|
|
Practical Automatic Screw Feeders Dispenser Multipurpose For Industrial Images
|
